Fabrication and Characterization of PDMS Waveguides for Flexible Optrodes.

With the growth of optogenetic research, the demand for optical probes tailored to specific applications is ever rising. Specifically, for applications like the coiled cochlea of the inner ear, where planar, stiff, and nonconformable probes can hardly be used, transitioning from commonly used stiff glass fibers to flexible probes is required, especially for long-term use. Following this demand, polydimethylsiloxane (PDMS) with its lower Young's modulus compared to glass fibers can serve as material of choice. Hence, the long-term usability of PDMS as a waveguide material with respect to variations in transmission and refractive index over time is investigated. Different manufacturing methods for PDMS-based flexible waveguides are established and compared with the aim to minimize optical losses and thus maximize optical output power. Finally, the waveguides with lowest optical losses (-4.8 dB cm-1 ± 1.3 dB cm-1 at 472 nm) are successfully inserted into the optogenetically modified cochlea of a Mongolian gerbil (Meriones unguiculatus), where optical stimuli delivered by the waveguides evoked robust neuronal responses in the auditory pathway.

Implantable Glass Waveguides and Coating Materials for Chronic Optical Medical Applications.

An innovative fabrication process of glass waveguides on silicon substrates for miniaturized implants is presented. Thin glass was bonded on oxidized silicon wafers and patterned using wet etching. Multimode waveguides with different shapes and a low surface roughness as well as low scattering of light were successfully fabricated. For efficient coupling of light and accurate alignment, KOH-grooves were etched in the silicon with respect to the glass waveguides to attach optical fibers from external light sources. Towards higher biostability, several coating materials were evaluated in accelerated in vitro tests in 60°C PBS for the first time over a long period of time regarding their optical properties. Ti02, SiC, polyimide, Parylene C and SU-8 showed a very stable optical transmittance after 320 days in accelerated aging while PECVDSi3N4 showed significant changes within the first days.

Hybrid surface design for robust superhydrophobicity.

Surfaces may be rendered superhydrophobic by engineering the surface morphology to control the extent of the liquid-air interface and by the use of low-surface-energy coatings. The droplet state on a superhydrophobic surface under static and dynamic conditions may be explained in terms of the relative magnitudes of the wetting and antiwetting pressures acting at the liquid-air interface on the substrate. In this paper, we discuss the design and fabrication of hollow hybrid superhydrophobic surfaces which incorporate both communicating and noncommunicating air gaps. The surface design is analytically shown to exhibit higher capillary (or nonwetting) pressure compared to solid pillars with only communicating air gaps. Six hybrid surfaces are fabricated with different surface parameters selected such that the Cassie state of a droplet is energetically favorable. The robustness of the surfaces is tested under dynamic impingement conditions, and droplet dynamics are explained using pressure-based transitions between Cassie and Wenzel states. During droplet impingement, the effective water hammer pressure acting due to the sudden change in the velocity of the droplet is determined experimentally and is found to be at least 2 orders of magnitude less than values reported in the literature. The experiments show that the water hammer pressure depends on the surface morphology and capillary pressure of the surface. We propose that the observed reduction in shock pressure may be attributed to the presence of air gaps in the substrate. This feature allows liquid deformation and hence avoids the sudden stoppage of the droplet motion as opposed to droplet behavior on smooth surfaces.